![]() ![]() Now, you’re set to use your ADT alarm panel in the best way possible.Īlso Read: How to put ADT system in test modeĪDT alarm systems are really essential for security purposes. So, do it beforehand.Īfter completing all the steps, remove your system from the test mode. In addition, note sometimes these batteries may need to be charged before activating. Also, reset the system to eradicate unnecessary messages popping on the screen. Lastly, perform the system test to ensure the system is working smoothly. Moreover, place the key on the top of the box before it is present. Also, screw it before using the screwdriver after closing the box and locking it back using the key. Now, plug the transformer back into the switch. Do this step by pushing the wire firmly to do it much more manageable. Connect the black wire to the black terminal and the redone to the red terminal. Now, just the way you disconnected the wire from the battery terminals, connect them back. Connect the wire to the battery terminals However, make sure you remove any of the outer plastic covering from the new battery or the connectors to avoid any mishap. Install the new batteryĪfter disconnecting the old battery, install the new one. It would cause a short circuit, harming you and others. However, make sure you do not touch any metal object to the battery terminal. It would be best to wiggle slightly to loosen it and remove it. Simply remove the black battery connector from the black battery terminal and the red battery connector from the red battery terminal. Disconnect the old batteryĪfter opening the control panel box, disconnect the old battery. The key is usually on the top of the control box, enabling immediate actions when needed. Open the control box using the keyĪfter unplugging the transformer, open the control box using the key. After doing so, a new message showing ‘No AC’ would appear on your keypad, indicating that the task to unplug the transformer has been done. Moreover, note that if there’s a screw present, you should remove it before unplugging the transformer. Also, it is generally white, beige, or black. This transfer is usually plugged into the regular household switch near the panel. The next step is to locate and unplug the transformer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |